Howto setup Rasbian Buster with BATMAN Mesh networking | raspberry pi 3 rasbian mesh batman network

I wrote this article a while ago about setting up BATMAN mesh networking with Rasbian Jesse on a Raspberry Pi 3.

This worked well, but stopped working with the newer versions of Rasbian, since there have been changes to the operating system.

After testing for several days, I found adding one command into the original script gets it to work just fine.

How to below.

After a fresh install of Rasbian Buster, connect to the system via ssh and run the following command to install BATMAN.

Lets create the mesh startup script.

The script will contain the instructions for bring up the interfaces and get  mesh, just change the IP address at the bottom on the next hosts, increment by one. Copy and past the following into the mesh.sh file.

Now let make the script executable.

And add to crontab so that its executed at every reboot

Add the following

Reboot and mesh should be up and running.

Test by executing the following command.

Should see something like this.

 

Leave a Reply

Your email address will not be published. Required fields are marked *